ECOMIRROR MURI
Elastic and heat - reflective paint
Self -cleaning, anti - mold / anti - algae paint
Excellent washability
Code
1013
Description
Finish based on self - cleaning and elastomeric acrylic emulsions modified with an additive which makes the paint harder, glass hollow micro -spheres of 3M, and special additives which give the product a high solarreflectance, a high thermal conductivity, a high anti - mold and anti - algae power, an excellent water repellence, a high resistance to UV - radiation and in highly alkaline environments, and finally an excellent permanent elasticity.
Use
This paint is suitable for facades with problems of micro - cracks or for structures subject to small deformations.
Appearance of the film
Matt
Color
White and color chart
Component
1
Hardening
Physical hardening through evaporation of water and union of the polymer
Specific weight
from 1,350 gr / ml
Volume of solids
50 %
VOC
120 gr/ litre
Minimum thickness
200 microns
Estimated yield
2,5 m² / litre for a thickness of 200 microns
Flash point
Component A > 114°C
Elongation %
ASTM 522 20%
Washability
> 10000 touches
Preparation of surfaces
New surfaces: remove all traces of dirt and of efflorescence and prime with a primer
Old surfaces:
Make sure that the old plaster adheres well to the substrate and, in the case of cracks wider than 1 mm, open and seal them with a suitable concrete – based sealant. Then treat the surface with a primer.
Old surfaces:
Make sure that the old plaster adheres well to the substrate and, in the case of cracks wider than 1 mm, open and seal them with a suitable concrete – based sealant. Then treat the surface with a primer.
Preparation of the product
Mix the product before the use.
If you use a roller or a brush, you have to thin the first coat of the product with 20 - 25 % of water.
Dilute the second coat with 10 - 15 % of water.
If you use a roller or a brush, you have to thin the first coat of the product with 20 - 25 % of water.
Dilute the second coat with 10 - 15 % of water.
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 200 microns 10° C 20° C 30° C
Dry to touch 24 6 1 hours
Dry in depth 24 8 2 hours
Dry to touch 24 6 1 hours
Dry in depth 24 8 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
24 8 3 hours
Maximum unlimited in the absence of contaminants
24 8 3 hours
Maximum unlimited in the absence of contaminants
Application
Roller, Brush
If you use the roller, you have to use medium - haired rollers or rollers with alveolar sponges
If you use the roller, you have to use medium - haired rollers or rollers with alveolar sponges
Shelf life
1 year in a cool and dry place (max 40° C)
Packs
Comp A Lt. 14 – Lt. 5