EPO FINISH AS W x muri e pavimenti
Epoxy coating based on water
Good mechanical and chemical resistance
Solvent - free, odouless
Code
1222
Description
Epoxy - amino finish based on water
Use
This product is used for the protection of concrete walls and floors, such as: corridors, ramps and loading areas, walls for food industries, floors in areas not subject to excessive chemical aggression. It is permeable to water vapour and it is easy to clean. It has an excellent abrasion resistance.
Appearance of the film
Semi - glossy
Color
White, Ral colors
Components
2
Hardening
Chemical reaction between two components
Specific weight
1,200 gr/ml (A + B)
Volume of solids
53%
VOC
0 gr/ liter
Minimum thickness
80 micron
Estimated yield
6,6 m² / litre for a thickness of 80 microns
Flash point
Component A > 113°C
Component B > 113°C
Component B > 113°C
Abrasion resistance
80 mg CS 17 1Kg 1000 cycles
Adhesion
On concrete 2,5 MPa On majolica - tiled stoneware 12MPa ASTM D 4541
Temperature resistance
Da -20 a + 100°C
Chemical resistance
Water, cleansing products, oils, fuels. It is not suitable for acid solutions and solvents.
Preparation of surfaces
Surfaces primed with « EPO W trasparente » or with « EPO W PRIMER ».
Preparation of the product
Mix the product according to the following ratio by weight:
Comp A 100
Comp B 30
Mix Component A separately and then add Component B, while stirring continuously. Mix and add 10 - 15 % of water.
Comp A 100
Comp B 30
Mix Component A separately and then add Component B, while stirring continuously. Mix and add 10 - 15 % of water.
Induction time
Not expected
Pot life
2 hours at 20° C
Thinning
10 – 15 % water
Environmental conditions
Ambient temperature: from + 5 to 35° C
Temperature of the support: > 10° C
Humidity: 0 - 70 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point
Temperature of the support: > 10° C
Humidity: 0 - 70 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point
Drying and hardening time
For the thickness of 80 microns (wet) 10° C 20° C 30° C
Dry to touch 6 3 1 hours
Dry in depth 10 8 5 hours
Dry to touch 6 3 1 hours
Dry in depth 10 8 5 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
18 8 5 hours
Massimum (months) 7 days
18 8 5 hours
Massimum (months) 7 days
Application
Brush, roller, airless, spray
If you use the brush, you have to use nylon or pure bristle brushes.
If you use the roller, use the method of crossing coats.
If you use the brush, you have to use nylon or pure bristle brushes.
If you use the roller, use the method of crossing coats.
Shelf life
2 years in a cool and dry place (max 40° C
Packs
Comp A 15kg Comp B 4,5 Kg