EPO Level
Self - leveling epoxy finish
Good mechanical and chemical resistance
To be applied on primed substrates
Code
227
Description
Epoxy - amino finish without solvent
Use
This product is used as a floor finish or as a self - leveling product mixed with quartz aggregates, preferably spheroidal
Appearance of the film
Glossy
Color
Ral colors
Components
2
Hardening
Chemical reaction between two components
Specific weight
1,500 gr/ml (A + B)
Volume of solids
99 %
VOC
30 gr/ liter
Dilution
max 5-10 with epoxy thinner depending on the temperature.
Minimum thickness
300 micron
Estimated yield
3,2 m² / litre for a thickness of 300 microns
Flash point
Component A cod. > 113° C
Component B cod > 115° C
Component B cod > 115° C
Abrasion resistance
60 mg 1000 cycles 1 kg wheel CS 17
Compressive modulus
2000 N / mmq
Elongation %
3 %
Thermal distortion
70°C
Chemical resistance
Alkaline solutions Cleansing products Inorganic acids Oils greases
Excellent Excellent Good Excellent
Excellent Excellent Good Excellent
Preparation of surfaces
To be applied on surfaces primed with the primer « EPO SS » or on mortars obtained with « EPO SS».
Preparation of the product
.Mix the product according to the following ratio by weight:
Component A: 100
Component B : 25
Mix Component A separately and then add Component B
Component A: 100
Component B : 25
Mix Component A separately and then add Component B
Self – leveling preparation
Add to the mixture (A + B) 70 parts of spheroidal quartz inert material (0,1 - 0,5) with a low speed mechanical mixer.
Pot life
40 minutes at 20° C
Environmental conditions
Ambient temperature: from + 10 to 35° C
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 300 microns 10° C 20° C 30° C
Dry to touch 8 3 1 hours
Dry in depth 16 8 5 hours
Dry to touch 8 3 1 hours
Dry in depth 16 8 5 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
10 8 5 hours
Maximum (days) 7
10 8 5 hours
Maximum (days) 7
Application
As a finish: roller, for small touches, use the brush.
As a self - leveling product: serrated spatula and bubble breaking roller.
If you use the roller, you have to use medium - haired rollers.
As a self - leveling product: serrated spatula and bubble breaking roller.
If you use the roller, you have to use medium - haired rollers.
Shelf life
2 years in a cool and dry place (max 40° C)
Packs
Comp A 20 kg Comp B 4Kg