Logo

EPO PRIMER W

Epoxy primer based on water

Adhesion promoter

It is suitable for wet surfaces

prodottibicomponenti

Code

1223

Description

It is a  polyamide - epoxy primer based on water

Use

This product is used on concrete floors with humidity problems, generally as an adhesion primer in environments where solvent - based products cannot be used.

Appearance of the film

Matt

Color

Light grey

Components

2

Hardening

Chemical reaction between two components

Specific weight

1,250 gr/ml (A + B)

Volume of solids

53%

VOC

0  gr/ liter

Minimum thickness

40 - 50 micron

Estimated yield

10,6 m² / litre for a thickness of 50 microns

Flash point

Component A                        >113°C
Component B                        >113°C

Adhesion

On concrete 2,5 MPa On majolica - tiled stoneware 12MPa  ASTM D 4541

Preparation of surfacesi

New concrete:
Chemical washing in order to remove laitance layers and efflorescence
Worn concrete:
Grinding, milling, shot peening, depending on the concrete conditions.
Grinding is suitable for removing surface dirt on consolidated concretes.
Shot peening and milling are more suitable for old and crumbling concretes or in case of removal of old paints.
These operations must always be followed by an appropriate dust removal.

Preparation of the product

Mix the product according to the following ratio by weight:
Component A :    100
Component B:      30
Mix Component A separately and then add Component B, while stirring continuously

Induction time

Not expected

Pot life

2  hours  a 20°C

Thinning

20 - 30 % with water

Environmental conditions

Ambient temperature:    from + 5 to 35° C
Temperature of the support:   > 10° C
Humidity:                   0 - 70  %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.

Drying and hardening time

For the thickness of 50 microns (wet)         10° C           20° C           30° C
Dry to touch                                                   6                 3                  1     hours
Dry in depth                                                  10                8                  5    hours

Time of overpainting

Minimum  (hours)                                 10° C          20° C            30° C
                                                              10              8                      5 hours
Maximum (months)                                             1

Application

Brush, roller, airless, spray
If you use the brush, you have to use nylon or pure bristle brushes.
If you use the roller, you have to use medium - haired rollers.
For the application, use the method of crossing coats.

Shelf life

2 years in a cool and dry place (max 40° C)

Packs

Comp A   15 kg      Comp B  4,5 Kg