EPO SS trasparente
Primer for concrete and stone substrates
Excellent wettability and penetration
It is suitable for wet surfaces
Code
219
Description
It is a modified polyaminoamide - epoxy primer without solvents
Use
This product is used as an anchor on concrete and stone substrates. It is suitable for preparing thick screeds and as an anchor for recasting.
Appearance of the film
Glossy
Color
Transparent
Components
2
Hardening
Chemical reaction between two components
Specific weight
1,150 gr/ml (A + B)
Volume of solids
100 %
VOC
0 gr/ liter
Minimum thickness
30 - 40 micron
Estimated yield
24 m² / litre for a thickness of 40 microns
Flash point
Component A > 113°C
Component B > 115°C
Component B > 115°C
Preparation of surfaces
New concrete:
Chemical washing in order to remove laitance layers and efflorescence Worn concrete:
Grinding, milling, shot peening, depending on the concrete conditions.
Grinding is suitable for removing surface dirt on consolidated concretes.
Shot peening and milling are more suitable for old and crumbling concretes or in case of removal of old paints.
These operations must always be followed by an appropriate dust removal
Chemical washing in order to remove laitance layers and efflorescence Worn concrete:
Grinding, milling, shot peening, depending on the concrete conditions.
Grinding is suitable for removing surface dirt on consolidated concretes.
Shot peening and milling are more suitable for old and crumbling concretes or in case of removal of old paints.
These operations must always be followed by an appropriate dust removal
Preparation of the product
Mix the product according to the following ratio by weight:
Component A: 100
Component B: 40
Mix Component A separately and then add Component B
Component A: 100
Component B: 40
Mix Component A separately and then add Component B
Induction time
Not expected
Pot life
1 hour a 20°C
Primer
Dilute to 40 - 50 % with an epoxy thinner
Preparation of mortars
Thick screeds:
Add 100 - 120 parts of inert material 0,1 - 0,5 to the mixture A + B
Add 100 - 120 parts of inert material 0,1 - 0,5 to the mixture A + B
Environmental conditions
Ambient temperature: from + 10 to 35° C
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 40 microns (wet) 10° C 20° C 30° C
Dry to touch 6 3 1 hours
Dry in depth 10 6 4 hours
Dry to touch 6 3 1 hours
Dry in depth 10 6 4 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
10 8 5 hours
Maximum (days) 30
10 8 5 hours
Maximum (days) 30
Application
Brush, roller, airless, spray
If you use the brush, you have to use nylon or pure bristle brushes.
If you use the roller, you have to use medium - haired rollers.
If you use the brush, you have to use nylon or pure bristle brushes.
If you use the roller, you have to use medium - haired rollers.
Shelf life
2 years in a cool and dry place (max 40° C)
Packs
Comp A 10 kg Comp B 4Kg