Nitrocolor Ruote

Code

0206

Description

Modified cellulosic nitro enamel

Use

The product is used as a finish for industrial vehicles, agricultural machines, industrial equipment. It ensures rapid drying and has good resistance to weathering, impacts and abrasion. It can be applied directly on sheet metal, The best results are obtained if the application is done on synthetic surfaces.

Appearance of the film

Brilliant

Colour

Alluminium

Component

1

Hardening

Physical by evaporation of solvents

Specific weight

1,080 – 1,120

Volume of solids

38%

Voc

385 gr/liter

Minimum thickness

50 – 60 micron

Estimated yield

6,3 m² / L for a thickness of 60 microns dry.

Flash point

6°C

Temperature resistance

Max 100°C

Preparation of surfaces

Surfaces primed with anti-rust RE or degreased sheet.

Preparation of the product

Mix the product before use and add the thinner
Component A 100
Thinner 30 – 40 % depending on the thickness of the dry film to be applied.

Environmental conditions

Ambient temperature:              from + 5  to 40°C
Temperature of the surface:     > 10°C
Humidity:                                  0 – 85 %
To prevent the formation of condensation the temperature of the surface
must be at least 3°C higher than the dew point

Drying and hardening time

For thicknesses of 60 microns                      10°C           20°C           30°C
Dry to touch                                                   1h               25’              12’
Dry in depth                                                    8h              2h               1h

Time of overpainting

Minimum (hours)                                        10°C          20°C            30°C
                                                                    12              8                   6
Maximum    Unlimited, except for the presence of contaminants on the
surface.

Application

Spray
Brush for touch ups only

Shelf life

2 years in a cool and dry place (max 40°C)

Packs

Kg. 20 - Lt. 4 - Lt. 0,750