PITTURA PER PISTE CICLABILI ALL'ACQUA
Waterproof barrier
Highly walkable and resistant to abrasion
Resistant to water stagnation
Code
875
Description
Elastic finish based on acrylic styrene emulsions and special internal additives that give the product excellent water repellency, high resistance to UV rays and to alkaline environments.
Use
Suitable for painting asphalt cycle paths or athletic tracks. After drying, the product forms an elastic layer resistant to weathering and abrasion.
Appearance of the film
matt
Colour
White – Colour chart
Component
1
Hardening
Physical by evaporation of water and coalescence of the polymer.
Specific weight
From 1,320 – 1,380 gr/ml
Volume of solids
58 %
VOC
120 gr/ liter
Minimum thickness
500 micron
Estimated yield
1,1 m² /L for a thickness of 500 microns dry.
Flash point
Component A > 114°C
Elongation %
50% for a dry thickness of 2000 microns.
Preparation of surfaces
Do a thorough cleaning by removing dust, peeling parts, grease and other contaminants. On surfaces with presence of old paints, prime with a hand diluted with 40-50% of the product. On new surfaces prime with a hand diluted 50%. Then, apply a second coat diluted 5-10%.
The surface must be dry, since the presence of excessive humidity inside the surface, in the phase of solar radiation, can generate steam which causes the formation of bubbles and the subsequent detachment of the coating.
The surface must be dry, since the presence of excessive humidity inside the surface, in the phase of solar radiation, can generate steam which causes the formation of bubbles and the subsequent detachment of the coating.
Preparation of the product
Mix the product before use.
For trowel applications the product must not be diluted.
For roller applications dilute the product with max. 5% of water
For trowel applications the product must not be diluted.
For roller applications dilute the product with max. 5% of water
Environmental conditions
Ambient temperature: from + 5 to 40°C
Temperature of the surface: > 10°C
Humidity: 0 – 85 %
To prevent the formation of condensation the temperature of the surface
must be at least 3°C higher than the dew point
.
Temperature of the surface: > 10°C
Humidity: 0 – 85 %
To prevent the formation of condensation the temperature of the surface
must be at least 3°C higher than the dew point
.
Drying and hardening
For thicknesses of 500 microns 10°C 20°C 30°C
Dry to touch 24 6 1 hrs
Dry in depth 24 8 2
Dry to touch 24 6 1 hrs
Dry in depth 24 8 2
Time of overpainting
Minimum (hrs) 10°C 20°C 30°C
24 8 3
Maximum Unlimited, except for the presence of contaminants on the
surface
24 8 3
Maximum Unlimited, except for the presence of contaminants on the
surface
Application
Spatula, roller.
For roller applications, use medium pile or honeycombed rollers
For roller applications, use medium pile or honeycombed rollers
Shelf life
1 year in a cool and dry place (max 40°C)
Packs
Comp A Lt. 14