RESIDUR
Resistant to corrosion
It is suitable for any substrate
Unsaponifiable, elastic
Code
0506
Description
One - component anti - corrosive primer formulated with unsaponifiable resins and anti - corrosion pigments. It has an excellent elasticity and adhesion on various substrates: steel, galvanized steel, light alloys, and so on.
Use
This product is used as an anchoring primer for difficult substrates such as galvanized steel, light alloys.
Appearance of the film
Matt
Color
yellow- green
Component
1
Hardening
Physical hardening through evaporation of solvents
Specific weight
0,960 gr/ml
Volume of solids
12 %
VOC
750 gr/ liter
Minimum thickness
15 - 30 micron
Estimated yield
4 m² / litre for a thickness of 30 micronsi
Flash point
Component A 25°C
Thinner 23°C
Thinner 23°C
Preparation of surfaces
New surfaces:
Steel: mechanical or manual cleaning in order to remove compact calamine, rust traces.
Galvanized steel or light alloys:
Remove any traces of oxides by a mechanical or manual cleaning.
Degrease the surface with suitable alkaline solutions or with a nitro thinner.
Make sure that the substrate is well dry and humidity - free.
Steel: mechanical or manual cleaning in order to remove compact calamine, rust traces.
Galvanized steel or light alloys:
Remove any traces of oxides by a mechanical or manual cleaning.
Degrease the surface with suitable alkaline solutions or with a nitro thinner.
Make sure that the substrate is well dry and humidity - free.
Preparation of the product
Mix the product before the use and add the thinner
Component A 100
Thinner 0 - 5 % nitro thinner
Component A 100
Thinner 0 - 5 % nitro thinner
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 5° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 5° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 20 microns 10° C 20° C 30° C
Dry to touch 6 1 0,5 hours
Dry in depth 12 4 2 hours
Dry to touch 6 1 0,5 hours
Dry in depth 12 4 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
12 4 2 hours
Maximum unlimited in the absence of contaminants
12 4 2 hours
Maximum unlimited in the absence of contaminants
Application
Brush, spray
If you use the brush, you have to use nylon or natural bristle brushes.
For the application, it is necessary to use the method of crossing coats.
If you use the brush, you have to use nylon or natural bristle brushes.
For the application, it is necessary to use the method of crossing coats.
Shelf life
6 months in a cool and dry place (max 40° C))
Packs
Comp A 2,5 lt. 0,500 lt. Thinner 1,5, 25 lt