RESIN GUM FBR
Fibre - reinforced waterproof barrier
UV resistant
Resistant to water stagnation
Codice
1006 FBR
Description
Elastic finish based on internally plasticised styrene - acrylic emulsions and natural fibres that give the product permanent elasticity and weather resistance after complete drying.
Use
This product is suitable for waterproofing concrete structures, foundations, parts of the wall that is not slightly seen below the surface of the road, and so on, roofs made of bituminous sheath, if you want to obtain good waterproofing at low cost. « RESIN GUM FBR » can be covered with ceramic products or it can be left as it is.
Appearance of the film
Matt
Colour
White – Red – Grey
Components
1
Hardening
Physical hardening through evaporation of water and union of the polymer
Specific weight
From 1,290 - 1320 gr / ml
Volume of solids
57 %
VOC
120 gr / litre
Minimum thickness
500 microns
Estimated yield
1,1 m² / litre for a thickness of 500 microns
Flash point
Component A > 114° C
Reflection percentage
White 80 %
Elongation %
50 % for a thickness of 2000 microns
Surface preparation
Perform an accurate cleaning to remove dirt, any parts that are peeling off, grease and other contaminants. Prime with our product « H 95 IMPRIMITURA » in case of very absorbent or floury surfaces, or our solvent - based product « PRIMER ALLA PLIOLITE ». In the case of new or old bituminous membranes, apply a coat of our water - based primer « BITUMPRIMER ».
The surface must be dry; the presence of excessive humidity inside the substrate, during solar radiation, can generate steam that causes the formation of bubbles and the subsequent detachment of the coating.
The surface must be dry; the presence of excessive humidity inside the substrate, during solar radiation, can generate steam that causes the formation of bubbles and the subsequent detachment of the coating.
Preparation of the product
Mix the product before use.
For spatula applications, do not dilute the product. For roller or brush application, dilute the product with 10 to 15% of water.
For spatula applications, do not dilute the product. For roller or brush application, dilute the product with 10 to 15% of water.
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the substrate: > 10° C
Humidity: 0 – 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the substrate: > 10° C
Humidity: 0 – 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For thicknesses of 500 microns 10° C 20° C 30° C
Dry to touch 24 6 1 hour
Dry in depth 24 8 2 hours
Dry to touch 24 6 1 hour
Dry in depth 24 8 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
24 8 3 hours
Maximum unlimited in the absence of contaminants
24 8 3 hours
Maximum unlimited in the absence of contaminants
Application
Brush, spatula, Roller
For roller application, use medium - haired rollers or rollers with alveolar sponges
For roller application, use medium - haired rollers or rollers with alveolar sponges
Shelf life
1 year in a cool and dry place (max 40° C)
Packs
Comp A Lt. 14 - Lt. 5 - Lt. 2,5