RESINELASTIC PR
It is certified for contact with drinking water
Excellent adhesion on mineral surfaces
Code
1215
Description
Two - component mortar based on cement, aggregates and resins in emulsion with high elasticity to be applied by brush or by roller.
Use
This product is used for the waterproofing of wells, terraces, bathrooms, showers, swimming pools, foundations, balconies and parts of the wall that is not slightly seen below the surface of the road. It is a product for an elastic skimming for the protection of plasters, plasterboard with cracks. « RESINELASTIC PR » may be covered with ceramic articles, or dispersion acrylic resins, or left as it is. This product has been certified to be suitable for contact with drinking water.
Appearance of the film
Matt
Color
Cement grey
Components
2
Hardening
Hydration of the cement and union of the polymer
Specific weight
From 1,720 gr/ml
VOC
4 gr/ liter
Minimum thickness
1 - 2 mm
Theoretical consumption
Application with a brush or a roller about 0,800 - 1 kg / m² for 1 mm of thickness
Application by spray with a plaster sprayer 2,4 kg / m² for 1 mm of thickness
Application by spray with a plaster sprayer 2,4 kg / m² for 1 mm of thickness
Flash point
Component A > 114°C
Preparation of surfaces
Carefully clean the surface by removing dust, all parts that are peeling off, grease and other contaminants, by pressure washing. In case of degraded surfaces, remove all parts that are peeling off and restore with suitable mortars.
Preparation of the product
Add the component A (powder) to the component B under mechanical stirring until you obtain a homogenous and thixotropic mixture.
Application of the product
« RESINELASTIC PR » must be applied within 60 minutes of mixing. Apply a first shaving coat with a brush or a roller, spread a plaster mesh and finish. After 4 - 5 hours, apply a second layer in order to fully cover the mesh.
Environmental conditions
Ambient temperature: from + 10 to 40° C
Temperature of the support: > 10° C
Humidity: 0 - 80 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 80 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
5 days 2 days 24 hours
5 days 2 days 24 hours
Application
Spatula, plaster sprayer.
Shelf life
1 year in a cool and dry place (max 40° C))
Packs
Comp A Kg. 20,000 CompB Kg. 10,000