Description
Transparent glossy or matt finish based on acrylic resins in water emulsion for the internal places and special particle - size pigments with a metallic effect, which gives a particular metallic effect to the substrate
Use
This product can be applied on already painted wall surfaces, concrete, plaster, cement, suitably prepared.
Appearance of the film
Matt - glossy
Colore
Transparent and color chart
Component
1
Hardening
Physical hardening through evaporation of water and union of the polymer
Specific weight
From 1,00 gr/lt
VOC
40 gr/ liter
Minimum thickness
40 micron
Estimated yield
4 – 5 mq/kg
Flash point
Component A > 114°C
temperature resistance
Max 60°C
washability
> 15000 touches
Preparation of surfaces
New surfaces: apply a coat of our insulating product « IMPRIMITURA ACRILICA » diluted with water in ratio 1 to 5 (mix each liter of « IMPRIMITURA ACRILICA » with 5 liters of water).
Old surfaces: remove any parts that are peeling off and, after a careful cleaning of the substrate, apply a coat of our insulating product « IMPRIMITURA ACRILICA » diluted with water in ratio 1 to 5 (mix each liter of « IMPRIMITURA ACRILICA » with 5 liters of water).
Old surfaces: remove any parts that are peeling off and, after a careful cleaning of the substrate, apply a coat of our insulating product « IMPRIMITURA ACRILICA » diluted with water in ratio 1 to 5 (mix each liter of « IMPRIMITURA ACRILICA » with 5 liters of water).
Preparation of the product
Product ready to use. Mix the product well before the use.
Component A 100
Component A 100
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 50 microns 10° C 20° C 30° C
Dry to touch 3 1 0,5 hours
Dry in depth 8 4 - 5 2 hours
Dry to touch 3 1 0,5 hours
Dry in depth 8 4 - 5 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
8 4 3 hours
Maximum unlimited in the absence of contaminants
8 4 3 hours
Maximum unlimited in the absence of contaminants
Application
After an appropriate preparation of the substrate, apply the product as follows: apply a coat of white or any color primer « SABBIAFOND » with a brush or a roller diluted with water to 20 - 25 %. When the substrate is completely dry, apply a coat of « SOFT », undiluted, with the special brush, the glove or the sponge, making circular or cross movements avoiding painting the same position in the same way or in a casual way. « SOFT » can be applied on any type of water - based paints.
Shelf life
2 years in a cool and dry place (max 40° C
Packs
Comp A Kg. 5 – Kg. 2