Finish based on modified glycerophthalic resins with non - yellowing siccative oils. a.
Use
This product is used as a finish for metal structures exposed in rural and marine environments.
Appearance of the film
polished / frosted
Color
White and color chart
Component
1
Hardening
Physical hardening through evaporation of solvents and oxidative polymerization
Specific weight
1,000 – 1,180
Volume of solids
51%
Voc
380 gr/liter
Minimum thickness
50 – 60 micron
Estimated yield
8,5 m² / litre for a thickness of 60 microns
Flash point
>34°C
Temperature resistance
Max 100° C continuously, 140° C discontinuously
Preparation of surfaces
Surfaces primed with anti - rust products such as “RESINFER”, “RESINCOR R.E.”, “RESINZINC”.
Preparation of the product
Mix the product before the use and add the thinner Component A 100 Thinner 5 - 10 % depending on the thickness of the dry film to be applied
Environmental conditions
Ambient temperature: from + 5 to 40° C Temperature of the support: > 10° C Humidity: 0 - 85 % In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 45 microns 10° C 20° C 30° C Dry to touch 4 2 1 hours Dry in depth 24 12 6 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C 24 12 6 hours Maximum unlimited in the absence of contaminants
Application
Brush, roller, spray. If you use the brush, you have to use nylon or natural bristle brushes. If you use the roller, you have to use short - haired rollers.