Description
One - component primer formulated with unsaponifiable resins and barrier effect pigments. Excellent elasticity and adhesion on various supports: steel, galvanised steel, light alloys, PVC, etc.
Use
As anchoring primer for difficult substrates such as galvanised steel, light alloys, PVC
Appearance of the film
Matt
Color
White - Transparent
Components
1
Hardening
Physical hardening through evaporation of solvents
Specific weight
1,290 gr / ml
Volume of solids
42%
VOC
509 gr/ litre
Minimum thickness
40 - 50 micron
Estimated yield
8,4 m² / litre for a thickness of 50 microns
Flash point
Component A 25° C
Thinner 23° C
Thinner 23° C
Preparation of surfaces
New surfaces:
Steel: mechanical or manual cleaning to remove compact scale, traces of rust.
Galvanised steel or light alloys:
Remove any traces of oxides by mechanical or manual cleaning.
Degrease the surface with suitable alkaline solutions or with nitro thinner.
Make sure the substrate is dry and not wet.
Steel: mechanical or manual cleaning to remove compact scale, traces of rust.
Galvanised steel or light alloys:
Remove any traces of oxides by mechanical or manual cleaning.
Degrease the surface with suitable alkaline solutions or with nitro thinner.
Make sure the substrate is dry and not wet.
Preparation of the product
Mix the product before the use and add the thinner
Component A 100
Epoxy Thinner 5 – 10 %
Component A 100
Epoxy Thinner 5 – 10 %
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 5° C
Humidity: 0 - 80 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 5° C
Humidity: 0 - 80 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 80 microns 10° C 20° C 30° C
Dry to touch 6 1 0,5 hours
Dry in depth 12 4 2 hours
Dry to touch 6 1 0,5 hours
Dry in depth 12 4 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
12 4 2 hours
Maximum unlimited in the absence of contaminants
12 4 2 hours
Maximum unlimited in the absence of contaminants
Application
Brush, spray
If you use the brush, you have to use nylon or pure bristle brushes.
Use the cross - hand method for application
If you use the brush, you have to use nylon or pure bristle brushes.
Use the cross - hand method for application
Shelf life
2 years in a cool and dry place (max 40° C)
Packs
Comp A Lt. 4 - Lt. 0,750 Thinner Lt. 5 - Lt. 25