VERNICE PER CEMENTO FACCIA VISTA A SOLVENTE
Resistent to atmospheric agents
Resistant to the abrasion
Water - repellent
Code
0830
Description
« VERNICE PER CEMENTO F.V. SOLVENTE » is a product based on acrylic - styrene resins with silicone modification, which makes the substrate water - repellent and highly resistant to the chemical and atmospheric agents.
Use
This product is used as a transparent finish where a good chemical resistance and a resistance to the abrasion are required. It can be used as an anti - dust for concrete.
Appearance of the film
glossy
Color
Opalescent transparent
Component
1
Hardening
Physical hardening through evaporation of water
Specific weight
0,930 gr/ml
Volume of solids
27 %
VOC
620 gr/ liter
Minimum thickness
60 -80 micron
Estimated yield
4,5 m² / litre for a thickness of 60 mcirons
Flash point
Component A 34° C
Thinner 34° C
Thinner 34° C
Temperature resistance
Max 110° C continuously, 200° C discontinuously
Preparation of surfaces
New metal substrates:
Remove from the surface dust and contaminants such as grease and oils.
For new wood:
Give a first diluted coat, remove fiber raising woods by abrasion and give a second coat.
For new plaster
Appropriate dust removal: application of a diluted coat followed, after 24 hours, by another coat as it is or slightly diluted.
Remove from the surface dust and contaminants such as grease and oils.
For new wood:
Give a first diluted coat, remove fiber raising woods by abrasion and give a second coat.
For new plaster
Appropriate dust removal: application of a diluted coat followed, after 24 hours, by another coat as it is or slightly diluted.
Preparation of the product
Mix the product before the use and add the thinner.
Component A 100
Thinner: water 60 % - 80 % (First coat)
10 % - 20 % (Second coat)
Component A 100
Thinner: water 60 % - 80 % (First coat)
10 % - 20 % (Second coat)
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 20 microns 10° C 20° C 30° C
Dry to touch 6 3 2 hours
Dry in depth 48 24 10 hours
Dry to touch 6 3 2 hours
Dry in depth 48 24 10 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
24 12 6 hours
Maximum unlimited in the absence of contaminants
24 12 6 hours
Maximum unlimited in the absence of contaminants
Application
Brush, roller, spray
If you use the brush, you have to use nylon or natural bristle brushes.
If you use the roller, you have to use medium - haired rollers.
For the application, it is necessary to use the method of crossing coats.
If you use the brush, you have to use nylon or natural bristle brushes.
If you use the roller, you have to use medium - haired rollers.
For the application, it is necessary to use the method of crossing coats.
Shelf life
2 years in a cool and dry place (max 40° C)
Packs
Comp A Lt. 25 Lt. 5 Lt. 1