Zincon
One coat resistant to the bad weather
Suitable for any support
Resistant to the abrasion
Code
0105
Description
Finishing product based on modified thermoplastic acrylic resins
Use
It is used as a one coat product on metal supports such as iron, aluminium, cold or hot galvanized iron. It provides a good protection in rural or moderately aggressive environments.
Appearance of the film
semi-gloss
Colour
White and colors ral
Component
1
Hardening
Physical hardening through evaporation of solvents
Specific weight
1,100 – 1,200
Volume of solids
41 %
Voc
500 gr/liter
Minimum thickness
60 micron
Estimated yield
6,8 m² / litre for a thickness of 60 microns
Flash point
34°C
Temperature resistance
Max 110° C continually 200° C irregularly
Preparation of surfaces
New metal supports:
Remove from the surface dust and contaminants such as fats, oils, zinc salts, and so on.
For new cement
In order to free from dust, apply a diluted coat followed, after 12 hours, by a second coat, that can be undiluted or slightly diluted.
Remove from the surface dust and contaminants such as fats, oils, zinc salts, and so on.
For new cement
In order to free from dust, apply a diluted coat followed, after 12 hours, by a second coat, that can be undiluted or slightly diluted.
Preparation of the product
Mix the product before use and add the diluent
Component A 100
Diluent: synthetic diluent 15 % - 30 %
10 % - 15 % (second coat)
Component A 100
Diluent: synthetic diluent 15 % - 30 %
10 % - 15 % (second coat)
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 10° C
Humidity: 0 – 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 – 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For thicknesses of 60 microns 10° C 20° C 30° C
Dry to touch 6 hours 1 hour 0,5 hour
Dry in depth 18 hours 4 hours 2 hours
Dry to touch 6 hours 1 hour 0,5 hour
Dry in depth 18 hours 4 hours 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
24 6 4
Maximum unlimited in the absence of contaminants
24 6 4
Maximum unlimited in the absence of contaminants
Application
Brush, roller, spray
If you use the brush, you must use nylon or natural bristle brushes.
If you use the roller, you must use medium-haired rollers.
For the application, use the technique of the crossing hands.
If you use the brush, you must use nylon or natural bristle brushes.
If you use the roller, you must use medium-haired rollers.
For the application, use the technique of the crossing hands.
Shelf life
2 years in a cool and dry place (max 40° C)
Packs
Lt. 2,5; Lt. 0,750