ELASTOMUR AL QUARZO
Elastic, anti - mold and anti - algae paint
UV - resistant
Excellent washability
Code
0838
Description
Finish based on elastomeric acrylic emulsions modified with an additive which makes the paint harder and special additives which give the product a high anti - mold and anti - algae power, an excellent water repellence, a high resistance to UV - radiation and in highly alkaline environments, and finally an excellent permanent elasticity.
Use
This paint is suitable for facades with problems of micro - cracks or for structures subject to small deformations.
Appearance of the film
Matt
Color
White and color chart
Component
1
Hardening
Physical hardening through evaporation of water and union of the polymer
Physical hardening through evaporation of water and union of the polymer
From 1,350 gr/ml
Volume of solids
50 %
VOC
120 gr/ liter
Minimum thickness
200 micron
Estimated yield
2,5 mq / litro per uno spessore di 200 micron secchi
Flash point
Component A > 114°C
Elongation %
300 for a dry thickness of 300 microns
Preparation of surfaces
New surfaces:
remove all traces of dirt and of efflorescence and prime with a primer (BASE PLIOLITE H95 IMPRIMITURA)
Old surfaces:
Make sure that the old plaster adheres well to the substrate and, in the case of cracks wider than 1 mm, open and seal them with a suitable concrete – based sealant. Then treat the surface with a primer.
remove all traces of dirt and of efflorescence and prime with a primer (BASE PLIOLITE H95 IMPRIMITURA)
Old surfaces:
Make sure that the old plaster adheres well to the substrate and, in the case of cracks wider than 1 mm, open and seal them with a suitable concrete – based sealant. Then treat the surface with a primer.
Washability
> 10000 touches
Preparation of the product
Mix the product before the use.
If you use a spatula, you have not to dilute the product. If you use a roller, you have to thin the product with 5 - 10 % of water.
If you use a spatula, you have not to dilute the product. If you use a roller, you have to thin the product with 5 - 10 % of water.
Environmental conditions
Ambient temperature: from + 5 to 40° C
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Temperature of the support: > 10° C
Humidity: 0 - 85 %
In order to prevent the formation of condensation, it is necessary that the temperature of the substrate is at least 3° C above the dew point.
Drying and hardening time
For the thickness of 200 microns 10° C 20° C 30° C
Dry to touch 24 6 1 hours
Dry in depth 24 8 2 hours
Dry to touch 24 6 1 hours
Dry in depth 24 8 2 hours
Time of overpainting
Minimum (hours) 10° C 20° C 30° C
24 8 3 hours
Maximum unlimited in the absence of contaminants
24 8 3 hours
Maximum unlimited in the absence of contaminants
Application
Roller, Brush
If you use the roller, you have to use medium - haired rollers or rollers with alveolar sponges
If you use the roller, you have to use medium - haired rollers or rollers with alveolar sponges
Shelf life
1 year in a cool and dry place (max 40° C)
Packs
Comp A Lt. 14; Lt. 5.